WD-10i wall system

The WD-10i wall system was designed for forming dry radiant

wall systems, and can be installed in both new buildings and

when doing renovation works.

The panels are made by combining a milled 15 mm plaster-

board sheet, in which 10 mm Ø pipe coils are inserted to allow

water to pass, with a sheet of EPS 200 polystyrene, in order to

increase thermal efficiency.

Passive panels are used to close off the false wall spaces in

non active zones, and are made of 15 mm plasterboard sheets

coupled with EPS 200 polystyrene insulating panels, in order to

form fully insulated walls.

This system is suitable for heating

and cooling use

Distance between horizontal

profiles (primary framework)

100 cm

Distance between vertical profiles

(secondary framework) 60 cm

10X1.3 mm pipe

Indicating the circuit by marking

out on the panel.

Mixed press-fit, push-fit tee

The false wall’s supporting structure must be suitably sized in

order to support the weight of the radiant panels, connecting

piping, water, and any parts of other plants that pass through

the false wall.

For wall systems installation on outside walls is always recom-

mended because, besides being walls rarely covered complete-

ly in furniture, this method creates thermal barriers to the out-

side, preventing the walls from becoming cold in winter or hot in

summer, thereby significantly improving comfort.

30

Ceiling and wall radiant system – Product guide

Tel. +39 0425 75 88 11