CD-10i ceiling system

The CD-10i ceiling system was made for dry suspended radiant

ceiling systems, and can be installed in both new buildings and

when doing renovation works.

The CD-10i panels are modular and come in three different siz-

es 500x1200 mm, 1000x1200 mm, 2000x1200 mm, to allow the

greatest possible percentage coverage of the ceiling area avail-

able, by combining them suitably to suit the design of the room.

The panels are made by combining a milled-out 15 mm plaster-

board sheet, in which the pipe coils are inserted to allow hot or

cold water to pass, with a sheet of EPS 200 polystyrene, in or-

der to increase thermal efficiency towards the spaces involved.

This system is suitable for heat-

ing and cooling use

Primary framework

spaced at 80 cm

Secondary framework

spaced at 50 cm

CD- 10i ceiling panel with

polystyrene insulation behind it

Feed pipe

Support structure

Passive panels are used to close off the drop ceiling in non ac-

tive zones, and are made of 15 mm plasterboard sheets cou-

pled with EPS 200 polystyrene insulating panels, in order to

form fully insulated ceilings.

The suspended ceiling supporting structure must be suitably

sized in order to support the weight of the radiant panels, con-

necting and water piping, and any parts of other plants that

pass through the suspended ceiling.

22

Ceiling and wall radiant system – Product guide

Tel. +39 0425 75 88 11